Removal & Installation ("F" Body)

Remove ignition coils. Raise and support vehicle. Drain the engine oil. On A/T models, remove the torque converter cover. On all models, remove the engine mount through bolts. Remove the engine mount nuts.

NOTE: Remove the oil level sensor, located in the oil pan, before the oil pan is removed. The sensor may be damaged if the oil pan is removed first.

Raise the engine using Engine Support Adapters (J-28467-A) and Universal Support Fixture (J-41044). Disconnect oil level sensor electrical connector. Remove oil level sensor.
Remove the oil pan retaining bolts. Lower the rear of the oil pan while rotating outward. Remove the oil pan. Remove oil pan gasket. Clean oil pan gasket surfaces.
To install, reverse removal procedure. Install oil level sensor after oil pan is installed. Tighten all fasteners to specification. See TORQUE SPECIFICATIONS table. Fill crankcase to proper level with appropriate oil.