LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1997 >> Park Avenue Ultra >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 3.8L V6 - VINS [K,1] >> Overhaul >> Cylinder Block Assembly >> Rod Bearings

Rod Bearings

  1. Ensure bearing cap bolt holes and mating surfaces are clean and dry. Use connecting rod stud protector on rod cap bolts. Install inserts in connecting rod and cap. Lubricate bearings and crank pin.
  2. Replace upper and lower both bearings as a set. Install bearing cap. Tighten NEW rod bearing cap bolts to 20 ft. lbs. (27 N.m). Tighten bolts an additional 50 degrees using Torque Angle Meter (J-36660).
scientia non olet · About LEMON Manuals