LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1996 >> Roadmaster Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Front Brake Rotor >> Installation

Front Brake Rotor: Installation

  1. To install, reverse removal procedure. To adjust wheel bearings, tighten spindle nut to 12 ft. lbs. (16 N.m) while spinning rotor forward by hand. Back off nut until just loose, then hand-tighten.
  2. Tighten nut until either hole in spindle aligns with a slot in nut. DO NOT move nut more than 1/2 flat. Install NEW cotter pin. Tighten nuts and bolts to specification. See TORQUE SPECIFICATIONS  .
scientia non olet · About LEMON Manuals