LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1990 >> Reatta 2D Convertible, 4T60/ME9 >> Labor Times >> Other Variant >> Brakes >> Mechanical - Hydraulic >> Brake Shoes &/Or Pads >> Remove & Replace

Brake Shoes &/Or Pads: Remove & Replace

WARNING: This page is about the Reatta 2D Convertible, 440T4/ME9, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies ToNoteStandard HoursWarranty HoursSkill Level
All1.8B
Front or Rear,Both Sides1.0B
Combination Procedure: BRAKE CALIPER MOUNTING BORE: Hone cylinders or internal bores:
Each0.2B
Combination Procedure: BRAKE HOSE: Replace:
Includes: Bleed System.
Each Additional0.2B
One,w/ABS0.5B
One,w/o ABS0.3B
Combination Procedure: CALIPER: Overhaul:
Includes: Bleed System.
One,Double Piston,w/ABS0.9B
One,Double Piston,w/o ABS0.7B
One,Single Piston,w/ABS0.7B
One,Single Piston,w/o ABS0.5B
Combination Procedure: CALIPER: Replace:
Includes: Bleed System.
One,w/ABS0.5B
One,w/o ABS0.3B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
0.5B
Combination Procedure: WHEEL CYLINDER: Overhaul:
Includes: Bleed System.
One,Off Vehicle,w/ABS0.7B
One,Off Vehicle,w/o ABS0.5B
One,On Vehicle,w/ABS0.5B
One,On Vehicle,w/o ABS0.3B
Combination Procedure: WHEEL CYLINDER: Replace:
Includes: Bleed System.
One,w/ABS0.5B
One,w/o ABS0.3B