Strut Damper Assembly: Removal
- Remove upper strut-to-body mount nuts. Raise and support vehicle. Allow suspension to hang freely. Remove wheel. Install drive axle shaft boot protectors.
- If equipped with anti-lock brake system, disconnect wheel speed sensors. Remove brake line clip or bracket bolt. Scribe strut lower mount clamp outline on steering knuckle for camber alignment and reassembly reference.CAUTION: Support steering knuckle during strut removal to prevent tension from being applied to brake hose. DO NOT overextend drive axle shaft CV joints.
- Support steering knuckle to prevent overextending axle shaft. Remove strut-to-steering knuckle retaining bolts. Remove strut assembly. DO NOT chip or scratch coil spring coating.