Removal & Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1988 Cadillac Fleetwood, 1988 Cadillac DeVille, 1987 Cadillac Fleetwood, 1987 Cadillac DeVille, and 1986 Cadillac Fleetwood. However, it is still accessible from the selected car via links, so may be relevant.
- Discharge system pressure. Disconnect negative battery cable. Remove return hose. Drain reservoir. Unplug electrical connector from fluid level sensor. Remove reservoir to valve block mounting bracket bolt.
- Carefully pry reservoir from booster housing. To install, reverse removal procedure. Inspect "O" rings and replace if necessary. Install new grommets. See BLEEDING BRAKE SYSTEM in this article.