Vehicle Speed Sensor

Removal & Installation (Century)

Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL and INSTALLATION in this article. Remove screw on optic head and buffer amplifier. Disconnect electrical connection from printed circuit to buffer amplifier. Remove vehicle speed sensor. To install, reverse removal procedure.

Removal & Installation

(Electra Estate Wagon & LeSabre Estate Wagon)

1) Remove left trim panel. Remove 4 screws and pull speedometer assembly out far enough to disconnect vehicle speed sensor optic lead by removing screw.

2) Reach in hole where speedometer assembly was and disconnect vehicle speed sensor buffer amplifier connector from instrument panel. Remove speed sensor. To install, reverse removal procedure.