Removal & Installation: Speedometer

Removal & Installation (Century)

1) Remove left trim plate. Remove 4 screws holding lens to cluster assembly. Remove lens (on tilt wheel equipped models, it may help to remove tilt lever). Remove 4 screws holding speedometer head assembly to cluster.

2) Pull speedometer head assembly out far enough to disconnect speedometer cable by depressing clip while pulling back on speedometer cable. Remove screw holding vehicle speed sensor lead to speedometer head assembly. Remove speedometer. To install, reverse removal procedure.

Removal & Installation

(Electra Estate Wagon & LeSabre Estate Wagon)

1) Remove left trim cover. Remove 4 speedometer attaching screws. Disconnect speedometer cable at cruise control or transmission. Pull speedometer assembly out far enough to remove 2 instrument cluster bulbs and sockets.

2) Disconnect speedometer cable by depressing clip while pulling back on speedometer cable. Remove screw holding vehicle speed sensor optic lead to speedometer head assembly. Remove speedometer. To install, reverse removal procedure.

Removal & Installation (Skyhawk)

Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL and INSTALLATION in this article. Loosen Remove 2 screws attaching speedometer to rear of cluster. Remove speedometer. To install, reverse removal procedure.

Removal & Installation (Skylark)

1) Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL and INSTALLATION in this article. Remove 6 screws from lens. Carefully remove lens. Remove 5 screws from fuel gauge, speedometer and odometer assembly.

2) Remove fuel gauge. Disconnect odometer to circuit board connector. Remove speedometer and odometer. Remove circuit board from inside case. To install, reverse removal procedure.