Removal & Installation: Gauges

Removal & Installation (Century)

Disconnect battery ground. Remove left trim plate. Remove 4 screws holding lens and bezel to cluster assembly (on tilt wheel equipped models, it may help to remove tilt lever). Remove 2 screws retaining gauge and pull gauges straight out. To install, reverse removal procedure.

Removal & Installation (Electra & LeSabre)

Disconnect battery ground. Remove cluster housing assembly. Remove 5 screws holding lens to cluster carrier. Lift lens and bezel straight up. This also disconnects connector tabs to gauge. Remove screws holding gauge onto bezel. Remove gauges. To install, reverse removal procedure.

Removal & Installation

(Electra Estate Wagon & LeSabre Estate Wagon)

Disconnect battery ground. Remove left trim cover. Remove 4 screws securing gauges. Pull gauge assembly out far enough to disconnect 2 bulbs and sockets. Disconnect electrical connector and remove gauges. To install, reverse removal procedure.

Removal & Installation (Skyhawk & Skylark)

Disconnect battery ground. Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL and INSTALLATION in this article. Remove nuts attaching gauges to rear of cluster. Remove gauges. To install, reverse removal procedure.