Hydraulic Accumulator: Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1988 Cadillac Fleetwood, 1988 Cadillac DeVille, 1987 Cadillac Fleetwood, 1987 Cadillac DeVille, and 1986 Cadillac Fleetwood. However, it is still accessible from the selected car via links, so may be relevant.
- Before installing accumulator inspect "O" ring for damage and replace if necessary. Be sure "O" ring is in position on accumulator and is wet with brake fluid. Screw in accumulator. Wipe off any excess fluid.
- Turn ignition on. Check that "BRAKE" light goes out after one minute. Top off fluid reservoir up to "MAX" mark with a fully charged accumulator.