Installing fuel delivery line
- Slightly press both holders (1) for the differential pressure sensors in arrow direction.
- Guide in and install fuel supply line (2).
- Insert and position the fuel supply line (4) into the clamp (5).
- Hand-tighten the union nut (3).
- Turn union nut (2) until hand-tight.
- Tighten the union nut (3).
TIGHTENING TORQUES SPECIFICATION
| Fuel delivery line to high pressure pump | ||
|---|---|---|
| Coupling nut | tightening torque | 33 Nm |
- Tighten the union nut (2).
TIGHTENING TORQUES SPECIFICATION
| Fuel delivery line to high pressure pump | ||
|---|---|---|
| Coupling nut | tightening torque | 33 Nm |
- Push the fuel supply line into the snap fastener (2) and lock it.
The fuel supply line must audibly engage in the snap fastener (2).
- Secure clamps (1).
- Connect connectors (3) and lock.
The connector (3) must engage audibly.
- Tighten down screw (4).
TIGHTENING TORQUES SPECIFICATION
| Fuel line to cylinder head cover | ||
|---|---|---|
| 6x18 | tightening torque | 7 Nm |
Follow-up work
- Refer to INSTALLING ALL IGNITION COILS .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to ACTIVATING VEHICLE-SPECIFIC HIGH-VOLTAGE OR LOW-VOLTAGE VEHICLE ELECTRICAL SYSTEM .