Preparing New Part
NOTE:
RISK OF DAMAGE
Damage to the spindle drive .
Shifting the trunk lid manually can damage the spindle drive .
Damage to the spindle drive .
Shifting the trunk lid manually can damage the spindle drive .
- Only shift trunk lid slowly hand force.
NOTE:
TECHNICAL INFORMATION
Adhesive technology in the area of the outer skin (not for structural adhesion):
The bonding surfaces of the new parts may not sharpened or ground.
For more information see: 41 00... BMW bonding instructions
Adhesive technology in the area of the outer skin (not for structural adhesion):
The bonding surfaces of the new parts may not sharpened or ground.
For more information see: 41 00... BMW bonding instructions
NOTE:
Perform the steps on the left and right side.
- Mark the separating cut (1)
on the new part according to the separating cut (2)
on the vehicle + approx. 15 - 20 mm material allowance and cut.
(2) = Separating cut on the vehicle
- Adjust tail cowling in combination with trunk lid and rear lamps and secure.
- In areas (1)
to (3)
drill out 20 bores of dia. 4.2 mm for blind rivet.
In area (3) , be aware of the later installation of the bumper bracket (4) .
Area Number 1 2 2 2 3 18 - In areas (5) , prepare for joining using the bonded rivet method (with punch rivets).
- Remove new part and deburr holes.