Installing the connecting branches on the exhaust turbocharger for the cylinders 1 to 3

NOTE: RISK OF DAMAGE
Damage to the surface .
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage .

Do not use any metal-cutting tools.

Check the sealing ring (1) for damage, replace the connecting bracket (2) for cylinders 4 to 6 if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.
Check the sealing ring (1) for damage and replace the sealing ring (1) as needed.
Wet sealing ring (1) with approved lubricant grease.
INSTALLATION AID DESCRIPTION

Lubricants G14 900 ml, Can 83232360412

Courtesy of BMW OF NORTH AMERICA, INC.
Clean the sealing surface (1) using special tool 0 495 102 (11 4 470) .

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in and install the connecting bracket (1) for cylinders 1 to 3.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Connecting brackets on exhaust turbocharger
M6	tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Connecting brackets on exhaust turbocharger
M6	tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect and lock the tank vent line (1).
The tank vent line (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Connect and lock connectors (1) and (2).
The connectors (1) and (2) must audibly engage.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to FASTENING THE AUXILIARY COOLANT PUMP FOR THE EXHAUST TURBOCHARGER .
Refer to INSTALLING THE RIGHT INTAKE FILTER HOUSING (FRONT-END STRUT REMOVED) .
Refer to INSTALLING THE CLEAN AIR PIPE FOR CYLINDERS 1 TO 3 .
Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
Refer to INSTALLING UPPER CROSS CONNECTION .
Refer to INSTALLING THE FRONT-END STRUT .
Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
Refer to INSTALLING THE FRONT HOOD SEAL .