Installing the hydraulic unit

NOTE: TECHNICAL INFORMATION
Maintain conditions of absolute cleanliness.

Position hydraulic unit (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Replace nuts.
Parts: Nuts
Install the nuts (1) and tighten.

TIGHTENING TORQUE SPECIFICATIONS

Hydraulic unit to pedal bracket
Replace nuts. M8 1x retightening at hydraulic unit after 10 min.	tightening torque	22 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Lock brake pedal (1) in place in the arrow direction with the brake booster.
Ensure that the brake pedal is completely locked with the brake booster!

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Do not interchange brake lines. Mark the brake lines before disassembly (for example, VL/VR/HR/HL) .
Do not bend brake lines.
Close off connecting bores with seal plugs.

Courtesy of BMW OF NORTH AMERICA, INC.

Fit brake lines (1) and tighten.

TIGHTENING TORQUE SPECIFICATIONS

Brake pipe screw connection/Union screws
tightening torque	17 Nm

Connect connector (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1).
Install the cable clip (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
Refer to FLUSHING THE REAR BRAKE AND AIR BLEED (AFTER PART EXCHANGE) .
Refer to FLUSHING AND BLEEDING FRONT BRAKES (AFTER PART EXCHANGE) .
Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID (AFTER PART EXCHANGE) .
Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .
Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
Refer to INSTALLING WINDSHIELD PANEL COVER .
Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
Refer to INSTALLING THE REAR HOOD SEAL .
Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
Refer to FUNCTIONAL CHECK OF INTEGRATED BRAKE SYSTEM .
Refer to DSC UNIT STARTING-UP/DRIVING DYNAMICS SENSOR ADJUSTMENT/CONTROL UNIT PROGRAMMING .