Mount rear brake guard plate
- Install brake guard plate (2) .
- Insert screws (1) and tighten them.
TIGHTENING TORQUE SPECIFICATIONS
| Brake protection plate on the rear wheel carrier | ||
| M6x12 Replace screw. | tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING REAR BRAKE DISCS .
- Refer to GREASING BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE .
- Refer to INSTALLING REAR BRAKE PADS .
- Refer to PLACING THE BRAKE PADS ON THE BRAKE DISK/PUTTING THEM INTO OPERATION .
- Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .
- Refer to STARTING-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND BLADES (REAR BRAKE) .