Remove bearing bracket for pedal mechanism

Preliminary work 

• Vehicles without airbag module for driver and knee protection.
• Refer to REMOVING THE TRIM PANEL FOR PEDAL ASSEMBLY .

• Retract release tool 2 409 646  between brake pedal and brake booster.
• Apply support (1) of the release tool 2 409 646  on the bearing bracket. If necessary, position the support by rotating the screw on the release tool.

Courtesy of BMW OF NORTH AMERICA, INC.

• Push release tool 2 409 646  in the direction of the arrow and lever out the brake pedal from brake booster.

Courtesy of BMW OF NORTH AMERICA, INC.

• Disconnect plug connection (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock plug connection (1) and disconnect.

Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen nuts (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Release screw (1) and remove bearing bracket (2).

Courtesy of BMW OF NORTH AMERICA, INC.