Tightening the screw connections on the wheel carrier
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M240i xDrive, 2023 BMW M240i, 2023 BMW 230i xDrive, 2023 BMW 230i, and 2022 BMW M240i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Tighten the screw connection in the normal position.
Tighten the screw connection in the normal position.
- Slacken screw (1) on the control arm by one turn.
- Tighten down screw (1).TIGHTENING TORQUES SPECIFICATION
Control arm to wheel carrier M14
Replace screw.
Tighten in normal position.Joining torque 165 Nm Angle of rotation 90° - Detach the brake hose (1) from the bracket.
- Slacken screw connection (2) to the upper wishbone by one turn.
- Tighten screw connection (2).TIGHTENING TORQUES SPECIFICATION
Upper wishbone to wheel carrier M12
Replace screw and nut.
Tighten in normal position.Joining torque 100 Nm Angle of rotation 90° - Attach the brake hose (1) in the bracket.
- Slacken screw (1) on the control link by one turn.
- Tighten down screw (1).TIGHTENING TORQUES SPECIFICATION
Track arm to wheel carrier M12
Replace screw.
Tighten in normal position.Joining torque 100 Nm Angle of rotation 90° - Slacken screw connection (1) to the trailing arm by one turn.
- Tighten the screw connection (1).TIGHTENING TORQUES SPECIFICATION
Trailing arm to wheel carrier M12
Replace screw and nut.
Tighten in normal position.tightening torque 100 Nm