Tightening the screw connections on the control link
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M240i xDrive, 2023 BMW M240i, 2023 BMW 230i xDrive, 2023 BMW 230i, and 2022 BMW M240i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Tighten the screw connection in the normal position.
Tighten the screw connection in the normal position.
- Slacken nut (1) by one turn using standard tool (2).
Provide counter support to the screw in the process.
- Tighten nut (1).
Standard tool: Pivoting extension 1/2 inch
Pivoting extension 1/2 inch
Pivoting extension 1/2 inch (2)
TIGHTENING TORQUES SPECIFICATIONControl arm to rear axle support M12
Replace screw and nut.
Tighten in normal position.Joining torque 100 Nm Angle of rotation 90° - Slacken screw (1) by one turn.
- Tighten down screw (1).TIGHTENING TORQUES SPECIFICATION
Control arm to wheel carrier M14
Replace screw.
Tighten in normal position.Joining torque 165 Nm Angle of rotation 90°