Releasing the anti-roll bar link and wheel speed sensor from the wheel carrier

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M240i xDrive, 2023 BMW M240i, 2023 BMW 230i xDrive, 2023 BMW 230i, and 2022 BMW M240i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Loosen screw (1).
Release wheel speed sensor (2) from the wheel carrier.
Press the control link slightly downwards.
Release the nut (4).
Counter-hold at the Torx socket.
Release the anti-roll bar link from the wheel carrier.
NOTE: The following step(s) must be performed if the specified component(s) is/are installed.
Detach cable for wheel speed sensor from holder (3).

Courtesy of BMW OF NORTH AMERICA, INC.