Installing the engine of the hydraulic unit

WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.

Position the engine (3) of the hydraulic unit.
Make sure that the cable outlet is aligned in the direction of the hydraulic lines.
Tighten the screws (2).
Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.
Fasten the cover cap (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Position coating (2) made of foam material.
Attach adhesive tapes (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Position control unit (2).
Attach retaining strap (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in and position hydraulic unit (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to CONNECTING ALL BATTERY GROUND LEADS .
Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON RIGHT .
Refer to INSTALLING THE TOP LUGGAGE COMPARTMENT TRIM PANEL .
Refer to INSTALLING LOADING EDGE TRIM .
Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .