Installing the tension spring for the trunk lid
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Shutting hood or trunk lid.
Injury hazard!
Injury hazard!
- Support hood/trunk lid in fully open position with the aid of a suitable device.
CAUTION:
Tension spring.
Injury hazard!
Injury hazard!
- Wear hand protection while removing and installing the tension spring.
NOTE:
TECHNICAL INFORMATION
The notes on setting the closing force are a fundamental requirement for these repair instructions and must be complied with at all times.
For additional information see: 51 24... NOTES ON SETTING THE CLOSING FORCE ON THE TAILGATE
The notes on setting the closing force are a fundamental requirement for these repair instructions and must be complied with at all times.
For additional information see: 51 24... NOTES ON SETTING THE CLOSING FORCE ON THE TAILGATE
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Positions (1) up to (3) influence the closing force of the tension spring.
If changing the closing force is necessary: see additional information.
- Feed in the tension spring (1) at the hinge (3).
Reattach the tension spring (1) on the rear holder (2) in the same position.
Follow-up work
- Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON RIGHT .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .