Installing the model inscription at the rear
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Laser beam.
Injury hazard!
Injury hazard!
- Do not look into the laser beam.
- Mount the special tool 2 407 566 on the tripod.
- Switch on laser (Position without automatic level).
- Activate laser horizontally and vertically.
- Position the special tool 2 407 566 to the rear of the vehicle.
- Align vertical laser beam (A) according to specified dimension.TECHNICAL DATA SPECIFICATION
Model inscription on the right side of the trunk lid Dimension A from corner of trunk lid 175 mm - Align horizontal laser beam (B) according to specified dimension.TECHNICAL DATA SPECIFICATION
Model inscription on the right side of the trunk lid Dimension B from horizontal edge of trunk lid 40 mm TECHNICAL DATA SPECIFICATIONModel inscription on the right side of the trunk lid Dimension B from horizontal edge of trunk lid 50 mm - Clean the adhesive area on the tailgate.CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Adhere to the air drying time of 2 min.
- Detach the liner from the adhesive strip of model inscription on the right.
- Align the model inscription on the right with the laser beams as shown, position it on the tailgate and press on it.