Installing the side attachment part
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
- Install attachment part (2) and engage it into the detents (arrows).
- Tighten down screw (1)
.TIGHTENING TORQUE SPECIFICATIONS
Lateral attachment part to bumper cover Hexagon screw Tightening torque 2.5 Nm
Follow-up work
- Refer to INSTALLING FOG LIGHT SUPPORT .
- Refer to PARTIALLY INSTALLING THE BUMPER BRACKET .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL .