Tightening the screw connection of the left and right camber link to the shock absorber
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the steps on the left and right side.
Tightening the screw connection of the camber link to the shock absorber
- Slacken the nut (1) by a turn and tighten it. Provide counter support to screw (2) in the process.
TIGHTENING TORQUE SPECIFICATIONS
| Rear shock absorber to the camber control arm | ||
| M12 Replace screw and nut. Tighten in the NORMAL POSITION . Tightening via nut. |
Tightening torque | 100 Nm |
| Angle of rotation | 90° | |