Tightening the screw connection of the bottom rear left and right control arm to the wheel carrier
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the steps on the left and right side.
Tightening the screw connection of the upper rear control arm to the wheel carrier
- Tighten nut (1) . In doing so, counter support at the eccentric screw (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Lower rear wishbone to wheel carrier | ||
| M12 Replace eccentric screw, eccentric washer and nut. |
Tightening torque | 100 Nm |