Fastening the wishbone, tension strut and tie rod end on the left and right on the swivel bearing

Attaching the wishbone, tension strut and tie rod end on the swivel bearing 

• Position the tie rod end (2)  on the swivel bearing.
• Replace nut (1)  .

  Parts:  Nut

• Tighten nut (1)  . If necessary, counter support at the Torx socket.
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Tie rod end to swivel bearing
  M14 Replace nut.	Tightening torque	165 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: TECHNICAL INFORMATION 
  Otherwise, the rubber grommet can be damaged. The components must not be in contact.
• Make sure that the rubber grommet (3)  on the wishbone (1)  is not damaged by the swivel bearing (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the wishbone (2)  on the swivel bearing (3)  .
• Replace nut (1)  .

  Parts:  Nut

• Tighten nut (1)  . If necessary, counter support at the Torx socket.

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Wishbone to swivel bearing
  M14 Replace nut.	tightening torque	175 Nm

  NOTE: Only perform the operation on the left side.
• Attach the attachment rod (1)  on to the ride height sensor (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the tension strut (2)  on swivel bearing (3)  .
• Replace nut (1)  .

  Parts:  Nut

• Tighten nut (1)  . If necessary, counter support at the Torx socket.

Courtesy of BMW OF NORTH AMERICA, INC.