Installing the anti-roll bar

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Install the anti-roll bar (1) from the side and position on the rear axle support.
Position the retainer.
Replace screws (2).
Parts: Screws
Tighten down screws (2).

TIGHTENING TORQUE SPECIFICATIONS

Retainer, anti-roll bar to rear axle support
M10 Replace screws.	tightening torque	56 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to SECURING THE LEFT AND RIGHT ANTI-ROLL BAR LINK ON THE ANTI-ROLL BAR .
Refer to INSTALLING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .
Refer to INSTALLING THE REAR LEFT WHEEL .