Install transmission oil pan (all-wheel drive vehicle) (GA8HP75Z, GA8HP76Z)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: TECHNICAL INFORMATION
The transmission oil pan and seal must be replaced each time after loosening.

Clean the contact surface of the transmission oil pan on the transmission.
Replace screws (1) to (13).
Parts: Screws
Position the transmission oil pan.
Hand-tighten the bolts.
Tighten the screws in the sequence (1) to (13).

Fig 1: Oil Pan Screws Tightening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Transmission oil pan
M6 Replace screws.	tightening torque	10 Nm

If necessary, tighten the oil drain plug (1).

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Oil drain plug
M18 Replace screw.	tightening torque	8 Nm

Follow-up work

Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
Refer to INSTALLING REAR UNDERBODY PROTECTION .