Installing washer fluid reservoir

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Connect all connectors (1).
Clip the cable into the washer fluid reservoir (3) (arrows).
Connect hose line (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in the washer fluid reservoir (1) towards the back in the holders (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten down screw (2).

TIGHTENING TORQUES SPECIFICATION

Washer fluid reservoir
tightening torque	8 Nm

Connect the hose pipe (1) of the headlight cleaning system.
Clip hose pipe (1) into the washer fluid reservoir (3).

Courtesy of BMW OF NORTH AMERICA, INC.
Clip the filler channel (1) downwards into the washer fluid reservoir (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER .
Refer to INSTALLING THE MOUNTING OF THE HOOD SEAL .
Refer to INSTALLING THE LID FOR THE WASHER FLUID RESERVOIR .
Installing the rear right engine compartment cover.

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the battery cover .

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
- Remove the special tool 2 452 007 from the battery.
Courtesy of BMW OF NORTH AMERICA, INC.
- Install the cover (2).
- Lock the lock (1).
Refer to INSTALLING THE FRONT RIGHT WHEEL .
Refer to RESETTING THE TIRE PRESSURE MONITOR .