Installing the rear bumper cover
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the plug connections and install bumper cover (2).
- Snap the bumper cover (2) into the locks (3) at the top.
- Snap the bumper cover (2) into the remaining locks on the side and at the bottom.
- Tighten down screws (1).TIGHTENING TORQUE SPECIFICATIONS
Bumper cover to guide, middle 2.7 Nm - Tighten down screws (1).TIGHTENING TORQUE SPECIFICATIONS
Bumper cover to side guide Screw Tightening torque 3 Nm
Follow-up work
- Refer to INSTALLING BOTH TAIL LIGHTS ON THE SIDE PANEL .
- Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL AT LEFT .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .