Remove left charge air cooler
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
WARNING:
Hot fluids.
Risk of scalding!
Risk of scalding!
- Conduct all work in the vehicle wearing appropriate personal protective equipment only.
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Preliminary work
- Refer to REMOVING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
- Refer to REMOVING THE COVER PANEL OF THE SLAVE DME CONTROL DEVICE .
- Refer to REMOVING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to REMOVING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to RELEASING LEFT FRONT-END STRUT .
- Refer to RELEASING THE RIGHT FRONT-END STRUT .
- Refer to REMOVING FRONT CROSS CONNECTION .
- Refer to REMOVING LEFT INTAKE SILENCER HOUSING .
- Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
- Refer to REMOVING FAN COWL WITH ELECTRIC MOTOR .
- Refer to REMOVING THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT .
- Refer to DRAINING THE COOLANT FROM THE COOLANT PUMPS .
- Unlock and disconnect plug connections (1).
- Open the cable bracket (2) and place the cable aside.
- Unlock the retaining clips (1) with a suitable screwdriver.
- Detach the coolant lines (2) and set aside.
- Thread the hose (1) out of the holder on the charge air cooler (4).
- Loosen hose clamp (3).
- Pull the hose (2) off the stud of the charge air cooler.
- Thread the hose (1) out of the holder on the charge air cooler (4).
- Loosen hose clamp (3).
- Pull the hose (2) off the stud of the charge air cooler.
- Loosen hose clamp (1).
- Loosen hose clamp (2).
- Release the wiring harness mounting (1).
- Loosen screw (2).
- Feed out the holder (3) downwards from the grooves (4).
- Carefully unlock and disconnect the line (1).
- Put the line to one side.
- Loosen screw (1).
- Unlock the bracket (2) upwards using a suitable screwdriver.
- Unlock the retaining clip (1) on the hose (2) with a suitable screwdriver.
- Detach hose (2).
- Loosen screws (1).
- Removing connecting plate (2) between charge air coolers.
- Release the hose clamps (1).
- Feed the charge air cooler (2) out toward the top and remove.