Replacing transmission oil cooler
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Loosen screw (1).
- Loosen screws (1).
- Remove cover panel (2).
- Feed out the transmission oil lines from the module bracket.
- Unlock the snap-in lug (1) on the unlocking (3).
- Guide out the transmission oil cooler (2) upwards.
- Replace the transmission oil cooler.
Parts: Transmission oil cooler
- Lock the transmission oil cooler (2) downwards in the detent (1).
- Feed in the transmission oil lines on the module bracket.
- Position the cover (2).
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Cover to cooler module mount | ||
| Screw TS4x16 | tightening torque | 1.5 Nm |
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Cooler module mount on transmission oil cooler | ||
| Screw TS6x20 | tightening torque | 2.8 Nm |