Install the external radiator on the right
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Position the radiator (4) with the holder (3) in the rubber mounts diagonally downwards towards the front bottom.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Holder for upper external radiator | ||
| Screw | Tightening torque | 11.8 Nm |
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Holder for side external radiator | ||
| Screw | tightening torque | 3.5 Nm |
NOTE:
Description is for left component only.
Procedure on the right side is identical.
Procedure on the right side is identical.
- Slide the coolant lines (2) forwards.
The retaining clips (1) must audibly engage.
If installed: Installing the right crossmember
- Position the right cross-member (2).
- Tighten down screws (1).
Follow-up work
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT RIGHT WHEEL ARCH COVER .
- Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
- Refer to INSTALLING THE FRONT RIGHT WHEEL .
- Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .