Removing rubber mount for the transmission bearing (all-wheel drive vehicle)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to REMOVING TRANSMISSION CROSS-MEMBER .
- Refer to DISCONNECTING THE CONNECTOR FROM VTG CONTROL UNIT .
- Use special tools 2 445 327 and 0 496 552 (33 3 010).
- Position the bridge (1) and centrally align the pressure disc (2) with the retaining lugs pointing towards the top on the rubber mount.
- Install the bridge (1) including pressure disc (2) and press out the rubber mounts in arrow direction.