Remove wiring harness section for the ignition system of cylinder bank 2

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Hot fluids .
Risk of scalding!

Conduct all work in the vehicle wearing appropriate personal protective equipment only.

NOTE: TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.

Preliminary work

Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
Refer to REMOVING THE ACOUSTIC COVER .
Refer to REMOVING THE COVER PANEL OF THE SLAVE DME CONTROL DEVICE .
Refer to REMOVING HOLDER OF DME CONTROL UNIT FOR CYLINDERS 5 TO 8 .
Refer to REMOVING COOLANT EXPANSION TANK .

Wiring harness section for the ignition system of cylinder bank 2

Courtesy of BMW OF NORTH AMERICA, INC.

Removing ignition coil of cylinder bank 2

NOTE: RISK OF DAMAGE
Damage to the ignition coil .
The silicone hose of the ignition coil must not be contaminated by fuel as this can lead to failure of the ignition coil .

When working on the fuel system, cover the ignition coils with suitable materials and remove where required.
Do not oil or grease the silicone tube of the spark plug socket. Do not use any protection or maintenance products (e.g. silicone spray, rubber care products, rust remover, etc.).

NOTE: The description is provided only at one component. The procedure is the same for all other components.

NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.

Unlock and disconnect the connectors (2) from the injectors with a small slotted screwdriver (1).
Unlock the lock in the direction of the arrow with a small slotted screwdriver (1). Disconnect the connector (2) on the connector housing from the injector.

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock the connectors (arrows) and disconnect.
Loosen nut (1).
Loosen screw (2).
Remove the cable clip (3) and put to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (1).
For equipment specification with RDE2:

Slowly pull the ignition coils (2) up and take them out without jerking them.

Pulling out the ignition coil with jerks may cause silicone hose to tear.

Courtesy of BMW OF NORTH AMERICA, INC.

After removing the ignition coils: Fuse off the silicone hose (1) of the ignition coils with an air gun (2).
The ignition coils must be free from oil, fuel residue, and coolant residue.

Courtesy of BMW OF NORTH AMERICA, INC.
Release the nuts in area (1).
Feed out the ground cable (2) and remove.
Thread out wiring harness section for the ignition system of cylinder bank (1) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.