Removing exhaust camshaft sensor of cylinder bank 1

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Hot surfaces .
Risk of burning!

Perform all work only on components that have cooled down.

NOTE: TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.

Preliminary work

Refer to REMOVING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
Refer to REMOVING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
Refer to RELEASING THE RIGHT FRONT-END STRUT .
Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .

Slightly press the line (1) to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock plug connection (1) and disconnect.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screw (1).
Remove exhaust camshaft sensor of cylinder bank 1 (2).

Courtesy of BMW OF NORTH AMERICA, INC.