Installing exhaust camshaft sensor of cylinder bank 1
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
Checking the sealing ring on the camshaft position sensor
Check
- Check the O-ring (1) on the camshaft position sensor for damage.
Result
» O-ring (1) damaged
Measure
- Replace O-ring (1) .
Parts: O-ring
Result
» O-ring (1) not damaged.
Measure
- Continue the repair in the next step.
- Coat O-ring on the camshaft position sensor with motor oil.
- Position exhaust camshaft sensor of cylinder bank 1 (2) .
- Tighten down screw (1) .
TIGHTENING TORQUES SPECIFICATION
| Camshaft position sensor | ||
| M6x16 screw | Tightening torque | 8 Nm |
- Connect connectors (1) and lock.
Follow-up work
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Installing the cover panel of the master DME control unit.
- Position the cover of the master DME control unit (1)
- Engage the cover panel of the master DME control unit (1) downwards with the clamps (2) and the guide pins (3) in the carrier plate of the DME.