Installing the exhaust camshaft sensor of cylinder bank 2
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
Checking the sealing ring on the camshaft position sensor
Check
- Check the O-ring (1) on the camshaft position sensor for damage.
Result
» O-ring (1) damaged
Measure
- Replace O-ring (1).
Parts: O-ring
Result
» O-ring (1) not damaged.
Measure
- Continue the repair in the next step.
- Position the exhaust camshaft sensor of cylinder bank 2 (2).
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Camshaft position sensor | ||
| M6x16 screw | Tightening torque | 8 Nm |
TIGHTENING TORQUES SPECIFICATION
| Fuel delivery line | ||
| Coupling nut | Tightening torque | 30 Nm |
WARNING:
Working on fuel system
.
Risk of fire! Danger of explosion!
Risk of fire! Danger of explosion!
- When working on the fuel system, make sure the workstation has sufficient ventilation, e.g., by means of extraction.
- Tightly seal off open lines and connections; collect any leakage fuel directly at the point of exit.
- No fire, sparks, open flames or smoking.
NOTE:
TECHNICAL INFORMATION
Wear protective gloves.
Wear protective gloves.
NOTE:
TECHNICAL INFORMATION
Wear safety goggles.
Wear safety goggles.
- Connect and lock the fuel line (1).
- Connect connectors (1) and lock.
- Position the holder for the sensor system (2).
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| Holder of sensor system | ||
| M6x16 screw | Tightening torque | 10 Nm |
- Position the coolant line (1) and clip it in.
- Push the line (2) to the side.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Fuel line | ||
| M6x16 | Tightening torque | 10 Nm |
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Fuel line | ||
| M6x16 | Tightening torque | 10 Nm |
Follow-up work
- Refer to MOUNTING THE FUEL SUPPLY LINE .
- Refer to CONNECTING THE CONNECTOR OF THE INJECTORS OF CYLINDER BANK 2 .
- Refer to INSTALLING THE IGNITION COILS OF CYLINDER BANK 2 .
- Installing conduit on bank 2.
- Clip the wiring harness (2) into the clamps (1).
- Refer to INSTALLING COOLANT EXPANSION TANK .
- Refer to INSTALLING HOLDER OF THE DME CONTROL UNIT FOR CYLINDERS 5 TO 8 .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to TIGHTENING THE LEFT FRONT-END STRUT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to INSTALLING THE COVER PANEL OF THE SLAVE DME CONTROL UNIT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING BATTERY GROUND LEAD .