Fastening the camber control arm and trailing arm on the left and right to the rear axle support
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the steps on the right and left side.
NOTE:
TECHNICAL INFORMATION
The screw connection is tightened later in the NORMAL POSITION with the torque wrench.
The screw connection is tightened later in the NORMAL POSITION with the torque wrench.
- Position the camber link and the trailing link on the rear axle support.
- Replace eccentric screw (2)
and screw (4)
.
Parts: Eccentric screw, screw
- Replace eccentric screw (2) and insert screw (4) .
- Position the eccentric washer.
- Replace the nuts (1)
and (3)
.
Parts: Nuts
- Tighten nuts (1) and (3) until hand-tight. Grip eccentric screw (2) or screw (4) in the process.
- Position the holder (2) of the attachment rod of the ride height sensor on the trailing link.
- Replace the screw (1)
.
Parts: Screw
- Tighten down screw (1) .
TIGHTENING TORQUES SPECIFICATION
| Jointed rod ride height sensor on wishbone | ||
| M6 | tightening torque | 8 Nm |