Install bearing bracket
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Coat the sealing ring (1) with front axle differential oil.
- Position the bearing bracket (2) at the engine oil pan.
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Bearing bracket to engine oil pan . | ||
| M8 | tightening torque | 19 Nm |
Follow-up work
- Refer to FOR REUSING: CHECKING THE GEARING OF THE OUTPUT SHAFT AND REPLACING THE CIRCLIP .
- Refer to INSTALLING RIGHT OUTPUT SHAFT .
- Refer to CHECKING/ADDING FRONT AXLE TRANSMISSION OIL .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE RIGHT SPRING STRUT HOLDER .
- Refer to SECURING UPPER WISHBONE, RIGHT, AT THE SWIVEL BEARING .
- Refer to REMOVING THE TOP SWIVEL BEARING ATTACHMENT .
- Refer to FASTENING THE RIGHT OUTPUT SHAFT ON THE WHEEL BEARING .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to FASTENING THE FRONT RIGHT SPRING STRUT .
- Refer to INSTALLING THE HOOD SEAL ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT THE RIGHT REAR .