Install the front top cross connection
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Attach the front top cross connection (4).
- Tighten down screws (3).TIGHTENING TORQUE SPECIFICATIONS
Front reinforcement strut screw Replace screws. Tightening torque 19 Nm - Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Top front cross connection to hood lock support screw Tightening torque 11.8 Nm - Tighten down screws (2).TIGHTENING TORQUE SPECIFICATIONS
Front Y-strut to cross connection and/or bumper bracket M6x20 screw Tightening torque 11.8 Nm - Mount the expanding rivets (1).
Follow-up work
- Refer to INSERT TOPPING AUTOMATIC AIR FLAP CONTROL .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to TIGHTENING THE LEFT FRONT-END STRUT .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING BOTH HEADLIGHTS .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to INSTALLING FRONT SECTION OF THE FRONT WHEEL ARCH COVER (PARTIALLY REMOVED) .