Install the rear top cross connection
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Position the cross connection at the upper rear (4) and guide in.
- Snap the cable clip (3) into the cross connection at the upper rear (4) .
- Tighten down screws (2)
.TIGHTENING TORQUE SPECIFICATIONS
Top rear cross connection center Tightening torque M8x20 screw 28 Nm - Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Top rear cross connection at side Tightening torque M8x30 screw 19 Nm
Follow-up work
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to TIGHTENING THE LEFT FRONT-END STRUT .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .