Insert top automatic air flap control

• Connect respective connectors and lock.
• Position the top air flap control (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The operations shown only for one side must be carried out on both sides.
• Fitting the top air flap control (1).
• Guide in the top air flap control (1) and clip it in with the ball head (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the cover (2).
• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Cross connection to front end
  Flat-head screw	Tightening torque	11.8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE FRONT BUMPER COVER .
• Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
• Refer to INSTALLING FRONT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT (PARTIALLY REMOVED) .
• Refer to INSTALLING THE COVER FOR CENTRAL ENGINE COMPARTMENT .
• Refer to INSTALLING THE FRONT HOOD SEAL .