Installing the rubber mount for the transmission mount (all-wheel drive)

• Version A: 

  Use special tools 2 445 327 and 0 496 552 (33 3 010). 

  Align pliers (1) centrally on the guide lug (4) of the rubber mount (3) and the recess (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Version A: 

  Install the shaped part (1) between the pliers (2) and the rubber mount (3).

  Screw pliers (2) tightly on rubber mount (3) remove shaped part (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Version B: 

  Use special tools 2 445 327 and 0 496 552 (33 3 010). 

  Align pliers (1) centrally on the mark (3) on the rubber mount (2) and the recess (4) on the pliers (1).

  Screw pliers (1) tightly on rubber mount (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Determine and use the respective pressure disc (3) according to the rubber mount.

  There are version A and B pressure discs.

  Rubber mount	Thrust washer
  A	A
  F	A
  G	A
  H	B
  M	B
  Y	B

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position pliers (4) over the pin (1).
• Using the screw connection (2), attach the pliers (4) to the rubber mount on the transfer box.
• Remove the pin (1).
• Align the surface (6) of the pressure disc (3) centrally with the surface (7) of the transfer box.
• Pull in the rubber mount to a distance (1) of approx. 10 mm.
• Release the screw connection of the pliers (3) along with the screw connection (2).
• Remove pliers (3).
• Pull the rubber mount with the thrust piece (4) up to the stop on the transfer box.
• Remove special tools 2 445 327 and 0 496 552 (33 3 010). 

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to CONNECTING THE CONNECTOR WITH THE VTG CONTROL UNIT .
• Refer to INSTALLING TRANSMISSION CROSS MEMBER .
• Refer to INSTALLING UNDERBODY PROTECTION AT REAR .