Installing the transmission oil pan (GA8HP50Z, GA8HP51Z, GA8HP75Z, GA8HP76Z)
NOTE:
TECHNICAL INFORMATION
The transmission oil pan and seal must be replaced each time after loosening.
The transmission oil pan and seal must be replaced each time after loosening.
- Clean the contact surface of the transmission oil pan on the transmission.
- Replace screws (1) to (13).
Parts: Screws
- Position the transmission oil pan.
- Hand-tighten the bolts.
- Tighten the screws in order from (1) to (13).
TIGHTENING TORQUES SPECIFICATION
| Transmission oil pan | ||
| M6 Replace screws. |
tightening torque | 10 Nm |
- If necessary, tighten the oil drain plug (1).
TIGHTENING TORQUES SPECIFICATION
| Oil drain plug | ||
| M18 Replace screw. |
tightening torque | 8 Nm |
Follow-up work