Preparing tires for installation
NOTE:
TECHNICAL INFORMATION
Before working with the special tool (RDC tool) for the first time, the web-based training "RDC tool" should have been completed successfully once. For this purpose, the web-based training "RDC tool" must be started in your Learning Management System (TMSi).
Before working with the special tool (RDC tool) for the first time, the web-based training "RDC tool" should have been completed successfully once. For this purpose, the web-based training "RDC tool" must be started in your Learning Management System (TMSi).
NOTE:
TECHNICAL INFORMATION
For the installation and removal of runflat tires and UHP tires, please note:
The work may only be carried out by persons who have the "Certified BMW tire fitter" certificate.
Only tire mounting machines approved and certified by BMW may be used.
Only mounting levers with a plastic cover approved by BMW and tire-mounting pastes approved by BMW may be used.
The installation procedure found in the operating instructions for the tire mounting machine and must be observed.
If tire sealant has been used, the built-in wheel electronics and the valve must be replaced.
For the installation and removal of runflat tires and UHP tires, please note:
The work may only be carried out by persons who have the "Certified BMW tire fitter" certificate.
Only tire mounting machines approved and certified by BMW may be used.
Only mounting levers with a plastic cover approved by BMW and tire-mounting pastes approved by BMW may be used.
The installation procedure found in the operating instructions for the tire mounting machine and must be observed.
If tire sealant has been used, the built-in wheel electronics and the valve must be replaced.
NOTE:
TECHNICAL INFORMATION
Follow the Owner's Manual provided by the manufacturer of the tire mounting machine.
Use only tire mounting machines that are in perfect condition to prevent damage to the wheel rim and/or the tire.
Follow the Owner's Manual provided by the manufacturer of the tire mounting machine.
Use only tire mounting machines that are in perfect condition to prevent damage to the wheel rim and/or the tire.
NOTE:
TECHNICAL INFORMATION
The customer is to be informed that strong acceleration or strong braking should be avoided initially.
The assembly paste can cause the tire to turn on the wheel rim and result in an imbalance.
The customer is to be informed that strong acceleration or strong braking should be avoided initially.
The assembly paste can cause the tire to turn on the wheel rim and result in an imbalance.
NOTE:
For 8WE optional equipment: tire data programming not possible
Preliminary work
- Refer to OBSERVE THE NOTES ON MOUNTING RSCS .
- Refer to PREPARING THE TIRES FOR DISASSEMBLY .
- Make sure that the tire has a temperature of at least 23°C.
- Clean the wheel and tire.
- Check wheel rim for wear, damage and burrs.
- Clean the tire beads and check for damage.
- Check the wheel electronics for damage and replace where required.
The tire valve must be replaced after the wheel electronics have been disassembled.