Removing the tie rod end

NOTE: TECHNICAL INFORMATION
Perform wheel alignment after installation.

NOTE: Description is for left component only. Procedure on the right side is identical.

Preliminary work

Release nut (1). If necessary, counter support at the Torx socket.
Release tie rod end (2) from the swivel bearing (3).

Courtesy of BMW OF NORTH AMERICA, INC.
Determine dimension (A) to simplify the following toe adjustment on the front axle.
Slacken screw (1).
Unscrew tie rod end.
If necessary, hold the track rod with an open-end spanner for counter support.

Courtesy of BMW OF NORTH AMERICA, INC.