Replacing coil spring

NOTE: TECHNICAL INFORMATION
Incorrect assembly is possible. Ensure correct installation position.

The installation position of the coil spring (1) is marked with a label (2).
The label (2) is attached to the upper coil spring end.

Courtesy of BMW OF NORTH AMERICA, INC.
Relieve the tension of the coil spring (1) by loosening the spindle (2).
Replace coil spring (1).
Parts: Coil spring

Courtesy of BMW OF NORTH AMERICA, INC.
Insert the bottom spring plate (1) sideways in arrow direction into the coil spring and turn it up to the lowest coil.
Insert the spindle (2) in the arrow direction through the bottom spring plate (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Insert the top spring plate (1) sideways in the coil spring, feed it in at the spindle (2) and turn to the top as far as possible.
Check the position of the spindle (2) with the hexagon head in the upper spring plate (1) and correct it if necessary.
Pull down the spindle (2) in arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.
Align the lower spring plate (1) with the opening for the lower coil spring end (2).

Courtesy of BMW OF NORTH AMERICA, INC.
NOTE:
RISK OF DAMAGE
Clamping the coil spring on the block. Damage of the coil spring.
- Do not clamp the coil spring on the block.
- Mind the distance between the spring coils.
Courtesy of BMW OF NORTH AMERICA, INC.
Tension the coil spring (1) using the spindle (2).
Check the position of the spring plate at the top and bottom in the coil spring and, if necessary, correct it.

Courtesy of BMW OF NORTH AMERICA, INC.