Install the rear right lower strap
NOTE:
TECHNICAL INFORMATION
Clean all belt fittings with microencapsulated male and female threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
Clean all belt fittings with microencapsulated male and female threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
NOTE:
TECHNICAL INFORMATION
Component is encoded against incorrect assembly.
Component is encoded against incorrect assembly.
- Position the right rear lower strap (3) properly.
- Tighten down screw (2).TIGHTENING TORQUES SPECIFICATION
Lower strap to body M12 screw Tightening torque 42 Nm - Connect connectors (1) and lock.
Follow-up work
- Refer to INSTALLING THE REAR SEAT .