Installing the front lower strap
NOTE:
TECHNICAL INFORMATION
Clean all belt fittings with microencapsulated male and female threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
Clean all belt fittings with microencapsulated male and female threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
NOTE:
TECHNICAL INFORMATION
Component is encoded against incorrect assembly.
Component is encoded against incorrect assembly.
- Insert and position the lower strap (3) .
- Replace the screw (1)
.
Parts: Screw
- Tighten down screw (1)
.TIGHTENING TORQUES SPECIFICATION
Lower strap to seat mechanism M10 screw Replace screw. Tightening torque 38 Nm - Connect the plug connection (2) and clip in any existing cable clips.
Follow-up work
- Refer to INSTALLING FRONT SEAT .